Having problems with or questions about SheetCam? Post them here.
-
Davek0974
- Posts: 286
- Joined: Sat Feb 01, 2014 2:07 pm
Post
by Davek0974 »
I have a job with some small internal details that have three rounded corners and one sharp corner.
The rounded corners have a 1.1mm radius applied and I'm using a 2mm cutter.
When I check "Sharpen Corners" it's sharpening all the corners, is there a way to stop this?
The angle threshold slider does nothing.
Thanks
-
Les Newell
- Site Admin
- Posts: 3668
- Joined: Thu May 11, 2006 8:12 pm
Post
by Les Newell »
Rounding the corners should work. Are you using a finish allowance? Finish allowance increases the effective cutter radius.
-
Davek0974
- Posts: 286
- Joined: Sat Feb 01, 2014 2:07 pm
Post
by Davek0974 »
Ah, thats a possible,
I will check that.
I used a 1.1mm rad in CAD but then requested a 2mm cutter plus 0.1mm finish allowance in CAM.
I guess I should have gone for a bigger radius?
-
Les Newell
- Site Admin
- Posts: 3668
- Joined: Thu May 11, 2006 8:12 pm
Post
by Les Newell »
Yes in that case your radius would have to be a touch bigger than 1.1mm