Hello, i have an old version of sheetcam we have been using for years with no problems. Today everything we open is tiny.....any ideas????
__._,_.___
Posted by: ezpz.zebra@yahoo.com
Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use
__,_._,___
drawings coming in small
drawings coming in small
Sounds like you were running in inch mode and now it’s in millimeter mode….
Brian Lamb
blamb11@cox.net (blamb11@cox.net)
www.lambtoolworks.com
On Aug 14, 2014, at 1:13 PM, ezpz.zebra@yahoo.com (ezpz.zebra@yahoo.com) [sheetcam] <sheetcam@yahoogroups.com (sheetcam@yahoogroups.com)> wrote:
__._,_.___
Posted by: Brian Lamb <blamb11@cox.net>
Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use
__,_._,___
Brian Lamb
blamb11@cox.net (blamb11@cox.net)
www.lambtoolworks.com
On Aug 14, 2014, at 1:13 PM, ezpz.zebra@yahoo.com (ezpz.zebra@yahoo.com) [sheetcam] <sheetcam@yahoogroups.com (sheetcam@yahoogroups.com)> wrote:
Hello, i have an old version of sheetcam we have been using for years with no problems. Today everything we open is tiny.....any ideas????
__._,_.___
Posted by: Brian Lamb <blamb11@cox.net>
Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use
__,_._,___
drawings coming in small
When you open the drawing a window pops up with a bunch of options. Make sure you set the drawing units to inches. If it is set to matric and your drawing is in inches it will end up very small.
Les
On 14/08/14 21:13, ezpz.zebra@yahoo.com (ezpz.zebra@yahoo.com) [sheetcam] wrote:
__._,_.___
Posted by: Les Newell <les.newell@fastmail.co.uk>
Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use
__,_._,___
Les
On 14/08/14 21:13, ezpz.zebra@yahoo.com (ezpz.zebra@yahoo.com) [sheetcam] wrote:
Hello, i have an old version of sheetcam we have been using for years with no problems. Today everything we open is tiny.....any ideas????
__._,_.___
Posted by: Les Newell <les.newell@fastmail.co.uk>
Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use
__,_._,___