plunge safety clearance in plasma
Posted: Tue Jun 17, 2014 7:56 am
It looks like SheetCam is expecting a decimal comma instead of a decimal point. This could be because your computer is set up to use a decimal comma or you have a language selected in SheetCam that uses a decimal comma.
Les
On 16/06/14 23:40, amigojalisco@yahoo.com.mx (amigojalisco@yahoo.com.mx) [sheetcam] wrote:
__._,_.___
Posted by: Les Newell <les.newell@fastmail.co.uk>
Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use
__,_._,___
Les
On 16/06/14 23:40, amigojalisco@yahoo.com.mx (amigojalisco@yahoo.com.mx) [sheetcam] wrote:
hello friends how are you?
i start to job with my plasma cnc machine but I set the safety clearance to prevent a collision between a court and  and pressed accept apear this image, and i can not continue, tanks for you suport my friends
Â
__._,_.___
Posted by: Les Newell <les.newell@fastmail.co.uk>
Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use
__,_._,___