Tapping Head setup
Posted: Sat Jun 07, 2014 2:53 am
I agree, but first we needed to establish the needs of the tapping sequence… that is independent of the code results at the moment.
Brian Lamb
blamb11@cox.net (blamb11@cox.net)
On Jun 5, 2014, at 9:58 AM, Don@Campbell-Gemstones.com (Don@Campbell-Gemstones.com) [sheetcam] <sheetcam@yahoogroups.com (sheetcam@yahoogroups.com)> wrote:
__._,_.___
Posted by: Brian Lamb <blamb11@cox.net>
Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use
__,_._,___
Brian Lamb
blamb11@cox.net (blamb11@cox.net)
On Jun 5, 2014, at 9:58 AM, Don@Campbell-Gemstones.com (Don@Campbell-Gemstones.com) [sheetcam] <sheetcam@yahoogroups.com (sheetcam@yahoogroups.com)> wrote:
OK, I’m talking about the process needed and not whatever code results you are getting from SC. I<<Brian, that code results from SC is the reason for this thread. Your example cleared up one major point for me though. I had overlooked the G04. If sheetcam can generate a G04, then the P value could be calculated by tap pitch, S, and Axial Travel. After a little more searching in Sheetcam, plasma does have a dwell, so I'm off on another path now to see if I can include a dwell cycle in the post. . thanks for turning on another light for me. Don
__._,_.___
Posted by: Brian Lamb <blamb11@cox.net>
Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use
__,_._,___