Posted: Thu May 01, 2014 4:32 pm
You can use points if you prefer but the problem is in the post. I have attached a fixed post that should work.
Save the file to any convenient folder on your computer then run SheetCam and go to Options->machine->post processor. Click on the 'import post' button. Using teh box that appears, navigate to the post and open it.
Les
On 01/05/2014 17:19, Jose Maria Garcia wrote:
__._,_.___
View attachments on the web
Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use
__,_._,___
Save the file to any convenient folder on your computer then run SheetCam and go to Options->machine->post processor. Click on the 'import post' button. Using teh box that appears, navigate to the post and open it.
Les
On 01/05/2014 17:19, Jose Maria Garcia wrote:
Hi Les,
Thank you for your fast response, and Yes, I am using a plasma cutter.
I followed a youtube video that directs you to put poits instead of holes for marking, is this correct? and yes it looks like it works on the simulation and not when post.
Regards,
Jose
__._,_.___
View attachments on the web
Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use
__,_._,___