PLATE MARKING Question
Posted: Thu May 01, 2014 2:43 pm
Hi there guys,
What would be the best way to mark on a plate, the center of (250)
1/4"(7mm)diameter holes, to be hand drilled later? Could you give me a step
by step help?
Thanks,
Jose
------------------------------------
Yahoo Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/sheetcam/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/sheetcam/join
(Yahoo! ID required)
<*> To change settings via email:
sheetcam-digest@yahoogroups.com
sheetcam-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
sheetcam-unsubscribe@yahoogroups.com
<*> Your use of Yahoo Groups is subject to:
https://info.yahoo.com/legal/us/yahoo/utos/terms/
What would be the best way to mark on a plate, the center of (250)
1/4"(7mm)diameter holes, to be hand drilled later? Could you give me a step
by step help?
Thanks,
Jose
------------------------------------
Yahoo Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/sheetcam/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/sheetcam/join
(Yahoo! ID required)
<*> To change settings via email:
sheetcam-digest@yahoogroups.com
sheetcam-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
sheetcam-unsubscribe@yahoogroups.com
<*> Your use of Yahoo Groups is subject to:
https://info.yahoo.com/legal/us/yahoo/utos/terms/