importing TAP files back into sheet cam

Having problems with or questions about SheetCam? Post them here.
Post Reply
oldtime
Posts: 4
Joined: Tue Nov 15, 2011 8:09 pm

importing TAP files back into sheet cam

Post by oldtime »

Hi all can this be done ? if so how thanks Mark Sunny Australia
Top
User avatar
Les Newell
Site Admin
Posts: 3668
Joined: Thu May 11, 2006 8:12 pm

Post by Les Newell »

Yes. Go to file->import drawing and make sure the file type is set to g-code. It does depend rather on what dialect of g-code you are using. G-code can vary quite a bit.
Top
Post Reply

Return to “Problems and questions”