Using SC on a router and a plasma cutter?
Posted: Sat Dec 15, 2012 2:55 pm
I would like to use SC that I have been using for both a mill and a router on a plasma cutter now.
Are there different profiles for Sheetcam?
In other words, the way I used it on the mill and router were similar.
Will setting up SC for a plasma lose the setting for the mill?
I always use an old job on both the mill and router when I update to new parts.
Would that method work the same in plasma?
If so, then I really have no other questions yet.![Cool 8)](./images/smilies/icon_cool.gif)
Are there different profiles for Sheetcam?
In other words, the way I used it on the mill and router were similar.
Will setting up SC for a plasma lose the setting for the mill?
I always use an old job on both the mill and router when I update to new parts.
Would that method work the same in plasma?
If so, then I really have no other questions yet.
![Cool 8)](./images/smilies/icon_cool.gif)