How about the ability to have both the mist and flood coolent on.
I also have a program with a large group of pockets (400), currently sheetcam seems to do some here and some there. If they were a contour operation I could optimize it and sheetcam cuts in groups.
Easy change
- Les Newell
- Site Admin
- Posts: 3668
- Joined: Thu May 11, 2006 8:12 pm
Why do I want both on at the same time... Cause I am not using them the way they are intended.
The mist turns on a dust collector, the flood turns on a vacuum pump that holds the parts in place.
I have one operation that cuts all 400 pockets. I attached the job if that helps show it. I also appreciate the help and understand that CNC training wasn't part of the purchase price.
The mist turns on a dust collector, the flood turns on a vacuum pump that holds the parts in place.
I have one operation that cuts all 400 pockets. I attached the job if that helps show it. I also appreciate the help and understand that CNC training wasn't part of the purchase price.
- Les Newell
- Site Admin
- Posts: 3668
- Joined: Thu May 11, 2006 8:12 pm
- Les Newell
- Site Admin
- Posts: 3668
- Joined: Thu May 11, 2006 8:12 pm