Hi Les,
in V0.0.16 the contour-process does only the 'outside-offset' - method correct. The 'no offset' - method creates the same code as the 'inside-offset' - method.
That means there is no 'no-offset' possible.
Please take a look.
Thank you
Richard
TNG V0.0.16 Milling problem
- Les Newell
- Site Admin
- Posts: 3675
- Joined: Thu May 11, 2006 8:12 pm
TNG V0.0.16 Milling problem
Hi Richard,
It has been fixed in the latest release. Sorry about that.
Les
ArchieF wrote:
It has been fixed in the latest release. Sorry about that.
Les
ArchieF wrote:
Hi Les,
in V0.0.16 the contour-process does only the 'outside-offset' - method correct. The 'no offset' - method creates the same code as the 'inside-offset' - method.
That means there is no 'no-offset' possible.
Please take a look.
Thank you
Richard
- Les Newell
- Site Admin
- Posts: 3675
- Joined: Thu May 11, 2006 8:12 pm
TNG V0.0.16 Milling problem
Hi Richard,
It has been fixed in the latest release. Sorry about that.
Les
ArchieF wrote:
-------------------- m2f --------------------
Reply to this post simply by hitting reply in your email client or you can read this topic online here:
http://www.forum.sheetcam.com/viewtopic.php?p=8509#8509
-------------------- m2f --------------------
It has been fixed in the latest release. Sorry about that.
Les
ArchieF wrote:
Hi Les,
in V0.0.16 the contour-process does only the 'outside-offset' - method correct. The 'no offset' - method creates the same code as the 'inside-offset' - method.
That means there is no 'no-offset' possible.
Please take a look.
Thank you
Richard
-------------------- m2f --------------------
Reply to this post simply by hitting reply in your email client or you can read this topic online here:
http://www.forum.sheetcam.com/viewtopic.php?p=8509#8509
-------------------- m2f --------------------