This question is so basic I'm embarrassed. When I import a DXF drawing into TNG I am given the option to position it in any corner or the center of the material. How do I offset it from a corner so it isn't tangent to the edge of the material? At one time I was able to drag the part outline within the material but I don't remember how.
Thanks.
-------------------- m2f --------------------
Reply to this post simply by hitting reply in your email client or you can read this topic online here:
http://www.forum.sheetcam.com/viewtopic ... 0801#10801
-------------------- m2f --------------------
How to position inported drawings?
- Les Newell
- Site Admin
- Posts: 3675
- Joined: Thu May 11, 2006 8:12 pm
How to position inported drawings?
Switch to nesting mode (the button that looks like a cross). Now drag the part with your mouse. Alternatively you can enter new coordinates at the bottom of the screen.
-------------------- m2f --------------------
Reply to this post simply by hitting reply in your email client or you can read this topic online here:
http://www.forum.sheetcam.com/viewtopic ... 0802#10802
-------------------- m2f --------------------
-------------------- m2f --------------------
Reply to this post simply by hitting reply in your email client or you can read this topic online here:
http://www.forum.sheetcam.com/viewtopic ... 0802#10802
-------------------- m2f --------------------