Hi all,
I have just uploaded V4.1.19 to www.sheetcam.com. This version has the following changes:
Fixed: Offsetting a line consisting of one segement not working
Fixed: 'Reverse open paths' not working when open paths are offset
Fixed: Open paths sometimes starting in the middle rather than one end.
Fixed: 'climb cut' not working for open paths
Fixed: Drawing remaining highlighted when it shouldn't be
Removed: 'Fixed' attribute for start points. Start points are now always fixed
Added: Better automatic optimisation
Fixed: Occasional incorrect part limits if part contains open paths
Fixed: Can now select parts in nesting mode even if they are only open paths
Added: scLoadTools and scSaveTools to plugin API
Les