After I've used Sheetcam what software should I use before exporting to a BURNEY 2.5 ?
As far as I can tell it needs.... *.nc
First correct answer wins....
First correct answer wins....
Hello 
After I've used Sheetcam what software should I use before exporting to a BURNEY 2.5 ?
As far as I can tell it needs.... *.nc
After I've used Sheetcam what software should I use before exporting to a BURNEY 2.5 ?
As far as I can tell it needs.... *.nc
-
Les Newell
- Site Admin
- Posts: 3668
- Joined: Thu May 11, 2006 8:12 pm
Re: First correct answer wins....
Sorry for the delay in answering but you should not need any extra software. In SheetCam go to Options->machine->post processor and select the burny25 post processor. Next change the 'Output file extension' setting to nc instead of tap.