Leadins and Tabs
-
- Posts: 452
- Joined: Wed Sep 12, 2018 8:18 pm
- Location: South Carolina, USA
- Contact:
Leadins and Tabs
Is there a way to do leadins on tabs in jet cutting?
- Les Newell
- Site Admin
- Posts: 3668
- Joined: Thu May 11, 2006 8:12 pm
Re: Leadins and Tabs
Sorry, no there isn't at the moment. A workaround would be to put the tabs in the drawing but you'd have to be careful about the offset side as the outline would open.
-
- Posts: 452
- Joined: Wed Sep 12, 2018 8:18 pm
- Location: South Carolina, USA
- Contact:
Re: Leadins and Tabs
Okay, no problem. Its not something i use very often, but would be a nice feature to add later if it doesnt cause other problems.