Post processor for HiCON controller?

Having problems with or questions about SheetCam? Post them here.
Post Reply
DynMetalworks
Posts: 11
Joined: Sun Nov 13, 2016 12:00 am

Post processor for HiCON controller?

Post by DynMetalworks »

I'm looking at getting a Vital Systems HiCON 7866 controller with ArcPro THC. It appears Vital Systems does not have a post processor setup. Is anyone else here using this controller and if so, what post are you using?
Top
robertspark
Posts: 257
Joined: Thu Feb 26, 2015 12:11 am

Re: Post processor for HiCON controller?

Post by robertspark »

it's not the controller but the CNC software that runs the controller that is important.

so look for a mach4 post processor if that is what CNC software you are running
Top
DynMetalworks
Posts: 11
Joined: Sun Nov 13, 2016 12:00 am

Re: Post processor for HiCON controller?

Post by DynMetalworks »

robertspark wrote: ↑Wed Dec 08, 2021 8:20 am it's not the controller but the CNC software that runs the controller that is important.

so look for a mach4 post processor if that is what CNC software you are running
Alright thanks
Top
Post Reply

Return to “Problems and questions”