Sheetcam Glitching/Failed G-code Question
Sheetcam Glitching/Failed G-code Question
Hello, Looking for some help on Sheetcam. This morning when I opened Sheetcam, in the upper left corner it has a ''glitched'' look to it. There are multiple boxes layered in the upper right corner (around where the Post Processor is). Also when I try to convert a DXF file, It only converts about half of the G-Code. Has anyone experienced this before? I have already tried to restore from a previous version and restore point to no avail. I very seldom use Sheetcam so I am not real familiar with it. Any advice or help would be greatly appreciated thank you for your time.