Hello,
I’m new to the forum but I was wondering if there is an easy way to mill one or 2 lines of a total part.
I tried to but it on different layers but then you need to cut compleet.
Maybe it isn’t possible and I need to make another drawing to do this. But maybe I can save a lot of time.
So I hope someone can help me. I it isn’t clear let me know.
Thanks
Milling one or 2 lines from a part
Milling one or 2 lines from a part
- Attachments
-
- 3B296880-3964-4D40-94AC-09C5BEFF8E67.jpeg (1.29 MiB) Viewed 955 times
Last edited by W4e on Mon Apr 05, 2021 11:05 am, edited 1 time in total.
Re: Milling one or 2 lines from a part
Unfortunately you can only select complete contours, not segments of it.
I don't know any workaround...
I don't know any workaround...
Re: Milling one or 2 lines from a part
Ah, I thought that already.
But I thought I double check it first. Thanks for your reply.
But I thought I double check it first. Thanks for your reply.