Hi,
I am using Sheetcam to generate gcode for multiple machines. Not just for myself but for customers to give support while they are training. I used to just make a copy of the EXE and named it to the machine to match. It would seem that that is no longer possible and I assume the feature of saving a machine will make up for that.
So my question is, is there a way to tell what machine config is loaded without having to go to the machine setup menu?
Also is it possible to assign a post processor to a machine config and have it load when that machine config i s loaded?
Multiple machines setup
- Les Newell
- Site Admin
- Posts: 3677
- Joined: Thu May 11, 2006 8:12 pm
Re: Multiple machines setup
Take a look at this thread. It covers multiple profiles viewtopic.php?t=6654&sid=18a46e9185fd7c ... ddc5688365