Hi Les,
I get a "some toolpaths were not generated correctly - please report this as a bug" when adding tabs to open paths.
I have only experienced this with release 6.9.17
Thanks
Adding tabs to open paths
-
- Posts: 9
- Joined: Sat Feb 29, 2020 4:10 am
Adding tabs to open paths
- Attachments
-
- Support.zip
- (27.69 KiB) Downloaded 48 times
- Les Newell
- Site Admin
- Posts: 3668
- Joined: Thu May 11, 2006 8:12 pm
Re: Adding tabs to open paths
There is very little room for the ramps and it is getting stuck trying to fit the ramps in. If you run simulation on that cut you'll see what I mean.
I'll try to fix it for the next release.
I'll try to fix it for the next release.