Outside Cut Lead In
-
- Posts: 2
- Joined: Sun Nov 03, 2019 9:57 pm
Outside Cut Lead In
I have been trying to process the attached with the work being an inside cut other than the O's middle which is an outside cut. But the lead-in on the center of the O is leading from inside instead of outside. I grouped the outside and inside using Autocad grouping. Any thoughts on the issue?
- Attachments
-
- Sheetcam Operations.PNG (25.75 KiB) Viewed 485 times
-
- Lead In Issue.PNG (176.14 KiB) Viewed 485 times
- Les Newell
- Site Admin
- Posts: 3668
- Joined: Thu May 11, 2006 8:12 pm
Re: Outside Cut Lead In
That's odd. Could you attach the job file (File->save job) with everything set up so I can take a look.
For this application I'd recommend putting everything on one layer and doing an inside offset. SheetCam will automatically detect the inside of the O needs to be cut on the other side. It will also cut the inside first.
For this application I'd recommend putting everything on one layer and doing an inside offset. SheetCam will automatically detect the inside of the O needs to be cut on the other side. It will also cut the inside first.