THC help

Having problems with or questions about SheetCam? Post them here.
Post Reply
SpoolnMS
Posts: 23
Joined: Mon Oct 28, 2019 12:25 am

THC help

Post by SpoolnMS »

I am using UCCNC with the Plasmasens/Plasmasensout and was wondering if its possible to do away with the G28/G31 command and manually set the torch on the top of the work piece (have sheetcam raise it a set amount) and allow the plasmasens to control the torch height. Am using the Mach 3 with thc/scriber post processor too.
Post Reply