Is there a way we can have Overburn and path rules tied to each tool so when i change tool it also brings in the overturn and path rule settings?
Thanks
Tool additions
- Les Newell
- Site Admin
- Posts: 3679
- Joined: Thu May 11, 2006 8:12 pm
Re: Tool additions
Currently there isn't any way to do this. May be able to add this if there is enough interest.
Re: Tool additions
And lead in and lead out settings, too. Since they usually change with the material being cut.
Re: Tool additions
One way I have been trying recently is saving a separate toolset for each material, doing that then saves each set of path rules for the material.
It's not a bad method and fairly quick to load up, don't really use overburn to be honest.
It's not a bad method and fairly quick to load up, don't really use overburn to be honest.
- Les Newell
- Site Admin
- Posts: 3679
- Joined: Thu May 11, 2006 8:12 pm
Re: Tool additions
Not many people expressed an interest so it's pretty low on the to-do list I'm afraid.
-
- Posts: 50
- Joined: Sun Nov 24, 2013 12:44 am
Re: Tool additions
I would be very grateful to add that option
Re: Tool additions
Fair enough, i'll keep my fingers crossedLes Newell wrote: ↑Mon Aug 19, 2019 3:58 pm Not many people expressed an interest so it's pretty low on the to-do list I'm afraid.