Hi
I am trying to install Sheetcam on a new Debian Stretch computer. These are the error messages I am getting:-
./SheetCamTNG-dev: error while loading shared libraries: libreadline.so.6: cannot open shared object file: No such file or directory
./SheetCamTNG-dev
./SheetCamTNG-dev: error while loading shared libraries: libwx_baseu-2.8.so.0: cannot open shared object file: No such file or directory
Also running Sheetcam .exe through wine. There is no post processor for LinuxCNC
Please help
Thanks
Can't install linux version of Sheetcam
- Les Newell
- Site Admin
- Posts: 3665
- Joined: Thu May 11, 2006 8:12 pm
Re: Can't install linux version of Sheetcam
I'm surprised it can't find wxWidgets. Does Stretch have a libreadline6 package? Also try installing libwxgtk2.8
Re: Can't install linux version of Sheetcam
This is what I get when I try to install the packages you suggest:
aaron@######:~$ sudo apt-get install libreadline6
[sudo] password for aaron:
Reading package lists... Done
Building dependency tree
Reading state information... Done
Package libreadline6 is not available, but is referred to by another package.
This may mean that the package is missing, has been obsoleted, or
is only available from another source
E: Package 'libreadline6' has no installation candidate
aaron@foam:~$ sudo apt-get install libwxgtk2.8
Reading package lists... Done
Building dependency tree
Reading state information... Done
E: Unable to locate package libwxgtk2.8
E: Couldn't find any package by glob 'libwxgtk2.8'
E: Couldn't find any package by regex 'libwxgtk2.8'
Is there a solution?
Also How can I add a LinuxCNC postprocessor to a windows version?
Thanks
Aaron
aaron@######:~$ sudo apt-get install libreadline6
[sudo] password for aaron:
Reading package lists... Done
Building dependency tree
Reading state information... Done
Package libreadline6 is not available, but is referred to by another package.
This may mean that the package is missing, has been obsoleted, or
is only available from another source
E: Package 'libreadline6' has no installation candidate
aaron@foam:~$ sudo apt-get install libwxgtk2.8
Reading package lists... Done
Building dependency tree
Reading state information... Done
E: Unable to locate package libwxgtk2.8
E: Couldn't find any package by glob 'libwxgtk2.8'
E: Couldn't find any package by regex 'libwxgtk2.8'
Is there a solution?
Also How can I add a LinuxCNC postprocessor to a windows version?
Thanks
Aaron