Orientating Plasma Torch With Pipe

Having problems with or questions about SheetCam? Post them here.
Post Reply
pdubbleyuh
Posts: 6
Joined: Fri Jul 21, 2017 9:49 pm

Orientating Plasma Torch With Pipe

Post by pdubbleyuh »

I overlooked a detail in Sheetcam, and now I'm not sure on where to look within the software - if you look at the attachment you will see my machine is zeroed on the left side of the pipe. I want the torch to be zeroed at the right side instead. How would I approach that?

Thanks.
Attachments
mach3pipe.jpg
mach3pipe.jpg (418.67 KiB) Viewed 2597 times
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Re: Orientating Plasma Torch With Pipe

Post by Les Newell »

Zero in SheetCam is zero on your machine. You need top move your part so it is to the left of zero. You may also want to move the material origin in SheetCam to the right hand side. You can do this in Options->job options.
Post Reply