looking for a post for a HC4500 plasma controller , found one in sheet cam, but my unit just looks like a bunch of arcs?
the odd file i had produced in deskcnc works,
it uses m7 and m8 for plasma torch, i used m3 and m5 in the past
I had been using a cnc4640 but wanted to add thc so purchased this hc4500 plasma unit, looks the same but software is completely different!
and my files don't work
HC4500 controller
-
- Posts: 3
- Joined: Sat Sep 29, 2018 10:03 am
Re: HC4500 controller
[img]IMG_6588.JPG/img][img]IMG_6584.JPG[img]IMG_6588.JPG/img]/img]
this is what I get, any help available, someone must of had this before?
this is what I get, any help available, someone must of had this before?
- Attachments
-
- IMG_6584.JPG (109.81 KiB) Viewed 15197 times
- Les Newell
- Site Admin
- Posts: 3675
- Joined: Thu May 11, 2006 8:12 pm
Re: HC4500 controller
Are you using the 'Adtech HC4500 abs arcs' post processor? If so, try the 'Adtech HC6500' post.
-
- Posts: 3
- Joined: Sat Sep 29, 2018 10:03 am
Re: HC4500 controller
Yes try that one similar results just a string of arcs?
I can't see any adjustment in the controller , funny but my old deskcnc files sort of work ?
I can't see any adjustment in the controller , funny but my old deskcnc files sort of work ?