Post Processor
-
- Posts: 3
- Joined: Fri Jul 27, 2018 11:20 am
Post Processor
Hello All, New to sheetcam and already have a problem! I bought my license, installed it, had an issue with the first project and processing, emailed Les, he answered and all was good. Ran a few projects with no problem then opened Sheetcam Wednesday to start another project and all the information was gone, reentered all the information, table size, material size but when I got to the post processor the list was gone. I tried downloading sheetcam again but that didn't help. Any ideas on how to get the post processors back in the drop down list? Thanks in advance!
-
- Posts: 3
- Joined: Fri Jul 27, 2018 11:20 am
Re: Post Processor
NEVER MIND, I figured out what was wrong!
- Les Newell
- Site Admin
- Posts: 3668
- Joined: Thu May 11, 2006 8:12 pm
Re: Post Processor
I haven't come across that one before. Is this on Linux or Windows?
-
- Posts: 3
- Joined: Fri Jul 27, 2018 11:20 am
Re: Post Processor
It was me Les, strained eyes, sleep deprived, way too tired to think straight! Sheetcam was not the issue, just me!