Tool additions

Request and discuss new features
Post Reply
Davek0974
Posts: 286
Joined: Sat Feb 01, 2014 2:07 pm

Tool additions

Post by Davek0974 »

Is there a way we can have Overburn and path rules tied to each tool so when i change tool it also brings in the overturn and path rule settings?


Thanks
User avatar
Les Newell
Site Admin
Posts: 3660
Joined: Thu May 11, 2006 8:12 pm

Re: Tool additions

Post by Les Newell »

Currently there isn't any way to do this. May be able to add this if there is enough interest.
User avatar
djreiswig
Posts: 471
Joined: Sat Feb 20, 2016 4:47 am
Location: SE Nebraska

Re: Tool additions

Post by djreiswig »

And lead in and lead out settings, too. Since they usually change with the material being cut.
SeanP
Posts: 217
Joined: Wed Oct 23, 2013 9:50 am

Re: Tool additions

Post by SeanP »

One way I have been trying recently is saving a separate toolset for each material, doing that then saves each set of path rules for the material.
It's not a bad method and fairly quick to load up, don't really use overburn to be honest.
Davek0974
Posts: 286
Joined: Sat Feb 01, 2014 2:07 pm

Re: Tool additions

Post by Davek0974 »

Any updates on this Les?

Still impossible?

:P
User avatar
Les Newell
Site Admin
Posts: 3660
Joined: Thu May 11, 2006 8:12 pm

Re: Tool additions

Post by Les Newell »

Not many people expressed an interest so it's pretty low on the to-do list I'm afraid.
luis lopez
Posts: 50
Joined: Sun Nov 24, 2013 12:44 am

Re: Tool additions

Post by luis lopez »

I would be very grateful to add that option
Davek0974
Posts: 286
Joined: Sat Feb 01, 2014 2:07 pm

Re: Tool additions

Post by Davek0974 »

Les Newell wrote: Mon Aug 19, 2019 3:58 pm Not many people expressed an interest so it's pretty low on the to-do list I'm afraid.
Fair enough, i'll keep my fingers crossed ;)
Post Reply