Is it possible to have the output from the rotary plugin dxf template in imperial instead of metric?
I know I can scale it in cad by 0.03937 but would be nice to output in inches.
Thanks
Dan
rotary template
- Les Newell
- Site Admin
- Posts: 3673
- Joined: Thu May 11, 2006 8:12 pm
Re: rotary template
That should happen automatically. Is SheetCam set to use inch units?
- Les Newell
- Site Admin
- Posts: 3673
- Joined: Thu May 11, 2006 8:12 pm
Re: rotary template
I just ran some tests and in inch mode it is multiplying the dimensions by 25.4 instead of dividing them. I'll release an update shortly.
Re: rotary template
sorry for delay.
That would make sense, when I bring the dxf in autocad I have to scale it twice by 0.03937 to get to incjes.
Thanks
That would make sense, when I bring the dxf in autocad I have to scale it twice by 0.03937 to get to incjes.
Thanks
Re: rotary template
any progress on an update for inch templates?
Thanks
Thanks