Hi Les,
Just wondering is there a reason why it's not possible?
It would be really useful if that was the case, all other modes you can add/edit operations.
Thanks
Sean
Edit operation while in nesting mode
Re: Edit operation while in nesting mode
No problem if not, keep wondering about this though nearly every time time I use sheetcam.
- Les Newell
- Site Admin
- Posts: 3668
- Joined: Thu May 11, 2006 8:12 pm
Re: Edit operation while in nesting mode
The problem is that each part has it's own set of operations. In Nesting mode you can select more than one part. I supose I could allow editing operations as long as you only have one part selected.
Re: Edit operation while in nesting mode
That would be great if you could Les, I'm sure there would be a good few others happy as well if it's possible.
Many thanks.
Many thanks.