Edit operation while in nesting mode

Having problems with or questions about SheetCam? Post them here.
Post Reply
SeanP
Posts: 217
Joined: Wed Oct 23, 2013 9:50 am

Edit operation while in nesting mode

Post by SeanP »

Hi Les,

Just wondering is there a reason why it's not possible?
It would be really useful if that was the case, all other modes you can add/edit operations.

Thanks
Sean
SeanP
Posts: 217
Joined: Wed Oct 23, 2013 9:50 am

Re: Edit operation while in nesting mode

Post by SeanP »

No problem if not, keep wondering about this though nearly every time time I use sheetcam. :P
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Re: Edit operation while in nesting mode

Post by Les Newell »

The problem is that each part has it's own set of operations. In Nesting mode you can select more than one part. I supose I could allow editing operations as long as you only have one part selected.
SeanP
Posts: 217
Joined: Wed Oct 23, 2013 9:50 am

Re: Edit operation while in nesting mode

Post by SeanP »

That would be great if you could Les, I'm sure there would be a good few others happy as well if it's possible.

Many thanks.
Post Reply