Post processor for prototrak 3 axis mill

General chat and non SheetCam related discussion
Post Reply
Buggytime
Posts: 3
Joined: Tue Oct 17, 2017 1:37 am

Post processor for prototrak 3 axis mill

Post by Buggytime » Thu Oct 19, 2017 10:56 pm

I run sheet cam on a swi prototrak mx2 mx3 and cam. I use the post processed for prototrak edge 2d for the mx2 (2 axis)and it works fine. But I try to use the other prototrak edge for the mx3 and cam for the 3 axis and it will not load the program. Is there another post processor is should use for my 3 axis programs? Thanks for any help.

Post Reply