I am getting the following error when I try and run some DXF files "radius to the end of the arc differs from the radius to the start 2508. I did a search and most suggest ij mode incremental I did this but it than just moves to a different line with the same error. I am at a loss of how to fix this issue.
I have attach a copy of the G code I am running and the DXF file and the post processor I am running in sheetcam
thanks in advance for the help.
Mike
Radius to end of arc differs from radius to startline
Radius to end of arc differs from radius to startline
- Attachments
-
- garage2.tap
- (160.43 KiB) Downloaded 377 times
-
- post.txt
- (4.53 KiB) Downloaded 378 times
-
- dads repair shop.dxf
- (492.96 KiB) Downloaded 387 times