SheetCAM Addon??

Posts redirected from the Yahoo mailing list
Post Reply
billfloyd806
Posts: 3
Joined: Thu Dec 22, 2016 9:44 pm

SheetCAM Addon??

Post by billfloyd806 » Tue Feb 28, 2017 6:30 pm

First, SHEETCAM is the best! I built my first plasma table and it works flawless. My question is do they make an addon for sheetcam that would allow me to cut heating/air cut work out? I've looked at some software, but WOW $$$$$$$. I figure this forum would be the best to ask around, can you recommend some software that will work and is affordable like SHEETCAM?

Thanks in advance

WyoGreen
Posts: 199
Joined: Wed May 07, 2014 10:02 pm

Post by WyoGreen » Tue Feb 28, 2017 11:54 pm

You might try a search over on PlasmaSpider.com.I know I have seem a few threads over there on this topic. It seems like there was mention of an online program that would do what you want for free.

Steve

billfloyd806
Posts: 3
Joined: Thu Dec 22, 2016 9:44 pm

Post by billfloyd806 » Wed Mar 01, 2017 1:41 pm

Thanks for the info

rrossetti
Posts: 7
Joined: Sun Jan 29, 2017 4:53 pm

Post by rrossetti » Wed Apr 26, 2017 7:20 pm


Appleber
Posts: 1
Joined: Tue Jan 02, 2018 10:36 am

Re: SheetCAM Addon??

Post by Appleber » Thu Jan 11, 2018 5:19 pm

WyoGreenr wrote:
Tue Feb 28, 2017 11:54 pm
You might try a search over on PlasmaSpider.com.I know I have seem a few threads over there on this topic. It seems like there was mention of an online program that would do what you want for free.
This sounds almost too good to be true, Steve. Do you recall the name of the software by any chance?

Post Reply