Hi,
I want to use Sheetcam's Mach3 plug-in but, this error massage comes:
*************
Mach automatic file transfer
If Mach is available, post processed files can be automatically transferred.
Mach NOT detected.
This plugin is disabled.
*************
I can't transfer the G-Codes which I made with sheetcam to Mach3.
I will be glad if you help me.
Agah.
------------------------------------
Sheetcam to Mach3
Sheetcam to Mach3
I believe this is a problem with the Mach installer. The only solution I
have found so far is to install a very early version of Mach then
install the latest version over the top of it.
Regards,
Les Newell
http://www.sheetcam.com
On 13/03/2012 11:31, senemhaskok wrote:
------------------------------------
have found so far is to install a very early version of Mach then
install the latest version over the top of it.
Regards,
Les Newell
http://www.sheetcam.com
On 13/03/2012 11:31, senemhaskok wrote:
Hi,
I want to use Sheetcam's Mach3 plug-in but, this error massage comes:
*************
Mach automatic file transfer
If Mach is available, post processed files can be automatically transferred.
Mach NOT detected.
This plugin is disabled.
*************
I can't transfer the G-Codes which I made with sheetcam to Mach3.
I will be glad if you help me.
Agah.
------------------------------------