G code issue

kbenz · Post by **kbenz** » Thu Aug 04, 2016 4:09 pm

I don't know if I changed a setting or what? when I run a new code on my plasma table (mach) the torch touches off, pierces and goes to the .060 cut height. but it stays locked there no matter the volts. If I run an older code it runs fine though.
Is there a setting somewhere?

Post by **Les Newell** » Thu Aug 04, 2016 5:49 pm

Have you changed your post processor? If you look at the old g-code it will probably show the name of the post processor used in the first few lines. Is this the same as the new code?

kbenz · Post by **kbenz** » Thu Aug 04, 2016 6:06 pm

just checked, it is the same MP1000-THC post processor

kbenz · Post by **kbenz** » Thu Aug 04, 2016 6:53 pm

what is a GO4 PO.4 and GO4 PO.5? this is inconsistant

kbenz · Post by **kbenz** » Thu Aug 04, 2016 7:42 pm

I see now the GO4 is a dwell

I changed my lead ins and outs from tangent(which I just started using) to arc and it ran fine??

Post by **Les Newell** » Fri Aug 05, 2016 11:38 am

The only other thing I can think of is possibly an issue with cutting rules do you use rules?

kbenz · Post by **kbenz** » Fri Aug 05, 2016 6:45 pm

Les Newell wrote:The only other thing I can think of is possibly an issue with cutting rules do you use rules?

No rules