Good Day Les
I am getting a change in output on Mach3 DRO for the A axis( tangential Blade) on straight lines and possibly only 1-2 line segments in a complete drawing. But if I single step through the same G-code the output performs as expected and no random changes.
I will try and include the G -code and a section of the drawing the fun starts at the vertical line after line 1730 of the code.
Any suggestion to get to the bottom of this would be much appreciated.
errant Tangential blade motion
errant Tangential blade motion
- Attachments
-
- problem.DXF
- (34.18 KiB) Downloaded 797 times
-
- problem.DXF
- (34.18 KiB) Downloaded 890 times