Second Flame profile question

Posts redirected from the Yahoo mailing list
Post Reply
steve@adnaironworks.co...

Second Flame profile question

Post by steve@adnaironworks.co... » Tue May 12, 2015 6:19 am

Hi Les, I have been wanting to have a second profile set up for flame cutting with Sheet-cam so I don't have to change the post processor and tool sets, is there a way to do this without a lot of confusion?
I have been using TNG for flame and TNG Development for plasma but I'd like the features of the development version for flame cutting.
I remember seeing something about it a while back but didn't quite understand how to make it work, could you explain it for a dummy?!


Thanks, Steve

__._,_.___
Posted by: steve@adnaironworks.com
Image

Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use



__,_._,___

Post Reply