Good evening
How would I set up a post to call the next tool right after a tool change?
Something like:
T3 (initial tool needed)
M7 (tool change)
T100 (next tool)
G0X20 (start to use T3)
Post question
- Les Newell
- Site Admin
- Posts: 3671
- Joined: Thu May 11, 2006 8:12 pm
-
- Posts: 8
- Joined: Wed Mar 24, 2010 7:53 pm
Forward looking tool change
Les, I have also wished for forward looking 'next' tool change. Add me to the list also.
- Les Newell
- Site Admin
- Posts: 3671
- Joined: Thu May 11, 2006 8:12 pm
I have been thinking about pre selecting tools. Currently SheetCam only tries to figure out the tool number at the start of an operation but I should be able to make some changes so it looks ahead to figure out what the next tool will be. What should happen on the last tool change? I guess you just don't output the pre-select tool number.