Feed hold on z move

cwalker1960 · Post by **cwalker1960** » Mon Jan 12, 2015 6:42 pm

Hi Les,
we talked about a post processor you had that would feed hold on z axis move. I have searched hard for it and can't find it. I need it for my milling machine which at present doesn't have z axis control and I have to manually set the z after each cycle. I am running the machine on mach 3 and I do have a DRO on the z axis. Just need it to hold feed and keep the spindle running.
Thanks

Post by **Les Newell** » Mon Jan 12, 2015 6:52 pm

Go to Options->machine->post processor and select the Mach3 2D post processor. This should do what you want.