Marius, try clicking new shape between each shape you put on the same sheet J
Tony Woodhouse
Advanced Digital Communications Ltd
Hubbell premises network wiring
Telecoms specialists
Converged Telecoms and Data.
T: 01246557788
M: 07710502125
E: tony@advanced-comms.co.uk
Registered in England : 5292508
From: sheetcam@yahoogroups.com [mailto:sheetcam@yahoogroups.com]
Sent: 26 December 2014 10:40
To: sheetcam@yahoogroups.com
Subject: [sheetcam] Multiple shapes
Hi Les
The shapes plugin is a very exciting development and it has been long awaited. Well done mate.
A question please. I tried to do multiple shapes on one job or sheet. Is this possible as it seemed to replace the current shape with the new shape.
Regards
Marius
http://www.cnccontrol.co.za
http://www.mastercut.co.za
__._,_.___
Posted by: "Tony Woodhouse" <tony@advanced-comms.co.uk>
Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use
__,_._,___