Hi all,
I have just uploaded V6.1.11 to www.sheetcam.com. This release has the
following changes:
Added: function post.SetEncoding to force g-code encoding
Added: I-beam support for rotary plasma
Changed: Measure now tries even harder to make sure the numbers are visible
Fixed: Hint icons for plugins such as RotaryPlasma stop working after
you load a job file.
Fixed: Occasional crash when deleting an operation
Fixed: Check box in face operation not enabling/disabling layer and
coordinate boxes.
Fixed: Tab mode remains disabled if you select a drilling/tapping
operation then delete it
Fixed: Simulation not displaying all languages correctly
Fixed: Variable type in variable definitions not translating correctly
Fixed: Tabs not cutting correctly if they are under a start point and
'cleanup exit ramp' is turned off
Les
------------------------------------
Posted by: Les Newell <les.newell@fastmail.co.uk>
------------------------------------
------------------------------------
Yahoo Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/sheetcam/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/sheetcam/join
(Yahoo! ID required)
<*> To change settings via email:
sheetcam-digest@yahoogroups.com
sheetcam-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
sheetcam-unsubscribe@yahoogroups.com
<*> Your use of Yahoo Groups is subject to:
https://info.yahoo.com/legal/us/yahoo/utos/terms/