Over cut on open line

[steve@adnaironworks.co...]

Hi Les, I sent you a job file to check, with over cut enabled it seems to cut along the same path back to .100 from X0.00. I have noticed it for a while and finally put my finger on it last night.
Now that I know what is happening I can leave the value at 0 and it's fine but I suspect it's not supposed to do it... I thought I'd post it here as well and see if anyone else has noticed it!


Thanks again, Steve


__._,_.___
Posted by: steve@adnaironworks.com


Visit Your Group

• New Members 1

Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use



__,_._,___