Thanks, Steve
__._,_.___
Posted by: steve@adnaironworks.com
Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use
__,_._,___
Tool set question
-
steve@adnaironworks.co...
Tool set question
I have been upgrading to a newer computer still with XP, when I copy and paste the tools they lose their name in the tool table... am I missing something simple here or is this normal?
Thanks, Steve
__._,_.___
Posted by: steve@adnaironworks.com
Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use
__,_._,___
Thanks, Steve
__._,_.___
Posted by: steve@adnaironworks.com
Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use
__,_._,___
Hi Steve,
Open the tool table and at the bottom, center is an option box - Automatically generate name. Uncheck that option, close SheetCam and reopen. Names should be restored.
I don't know how many tools you are copying and pasting, but I save my toolset (under File, Save toolset as) as a backup. To restore an installation, I Open toolset and then, if it's the default toolset, I select Save default toolset so it uses that toolset as default each time I open SheetCam.
HTH
Paul
Open the tool table and at the bottom, center is an option box - Automatically generate name. Uncheck that option, close SheetCam and reopen. Names should be restored.
I don't know how many tools you are copying and pasting, but I save my toolset (under File, Save toolset as) as a backup. To restore an installation, I Open toolset and then, if it's the default toolset, I select Save default toolset so it uses that toolset as default each time I open SheetCam.
HTH
Paul