Dear Group,
 I'm new on sheetcam and i was editing a post processor for plasma, and checking about path.
 I want to change Lead-in, Lead-Outs, Overburns and so, depenidng on shape to be cut. As on Path Rules, where two commands an speed change can be done, i want to change kind of Lead-In and rest of path editing, for example:
 - On small holes (small can be defined depending on material thickness) pierce on center and enter with arc, oberburn.
 - On internal square or linear cutting paths, pierce and lead in on 45º straight line
 - If external shape has some corner, lead in and enter with same direction as the line that is going to be cut at first.
 I supose it can be made with different layers, but want to simplify just configuring once and using with any DXF.
Best Regards,
Aitor.
__._,_.___
Posted by: Aitor <azerizorrofox@gmail.com>
Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use
__,_._,___