Hello!
I've got my chinese router (wk1313) up and running with sheetcam and I'm using the V-carve plugin.
It work great but for some reason the toolchange function does work but does not pause.
So the router shuts down and goes to the predefined location that I entered in sheetcam but starts right up again and continues.
It is logical to me that I must enter a "pause" command in "run code before toolchange" area but I'm not an expert and don't know the right code to enter.
toolchange
- Les Newell
- Site Admin
- Posts: 3668
- Joined: Thu May 11, 2006 8:12 pm
Use:Note that is M followed by the number zero.
Code: Select all
M0
- Les Newell
- Site Admin
- Posts: 3668
- Joined: Thu May 11, 2006 8:12 pm