Dragknife plugin

aaron · Post by **aaron** » Fri May 02, 2014 1:12 pm

Hi Cammers
Probably a stupid question but....I have payed for the drag knife plugin but can't find the download button.
Cheers
Aaron

Post by **Les Newell** » Fri May 02, 2014 2:08 pm

Did you receive the email describing how to install the license key? If you have the key, run SheetCam and go to Options->plugin options->knife. Enter your key. Now restart SheetCam and go to Options->machine and select the knife machine type.

aaron · Post by **aaron** » Fri May 02, 2014 4:38 pm

No i don't think I did get an email with instructions, but I did get an invoice which was nice.
Thanks for lovely softwares
Aaron

Post by **Les Newell** » Fri May 02, 2014 4:55 pm

Have you got the serial number? That would have been in the email and it may have been shown on the website after you paid.