THC Codes upset corners???

Davek0974 · Post by **Davek0974** » Mon Apr 07, 2014 10:42 am

Just a thought...

If we now have the excellent new rules system where I can choose to reduce speed for say a 30mm circle, is it best to now modify the POST file to remove the "slowdown on circles <xx dia" entry, maybe set it to 1mm or something like that.

reasoning was that if this was not done we would have two slowdown rules running - cutting rules plus POST rules??

rikduk · Post by **rikduk** » Mon Apr 07, 2014 11:43 pm

If im not mistaken, sheetcam will always take the lowest feedrate between 2 overlapping rules.

Davek0974 · Post by **Davek0974** » Tue Apr 08, 2014 6:28 am

Ok thanks, but to stop confusion or doubt, would it be a reasonable idea to disable the POST slowdown entry if we are using rules?

Post by **Les Newell** » Tue Apr 08, 2014 12:06 pm

The post does not know about rules and vice-versa. It is a good idea to disable slowdown in the post if you are using rules.