I have a series of circles that are to get an inside offset cut (automatically from an outside offset operation). When I add the overcut, a circle or two (not all) only have the lead-in, overcut length and lead-out, but no main cut. If I remove the overcut, the circle's cut path shows up. See screenshot.
I am running Ubuntu 12.04, SheetCam TNG Development 5.1.12 under Wine. Any ideas?
No Main Path Some Circles With Plasma Overcut
No Main Path Some Circles With Plasma Overcut
- Attachments
-
- OverCut.Incomplete.Circle.png (36.3 KiB) Viewed 2405 times
- Les Newell
- Site Admin
- Posts: 3668
- Joined: Thu May 11, 2006 8:12 pm
Re: No Main Path Some Circles With Plasma Overcut
I found the problem. I'll release an update shortly.PK wrote:I have a series of circles that are to get an inside offset cut (automatically from an outside offset operation). When I add the overcut, a circle or two (not all) only have the lead-in, overcut length and lead-out, but no main cut. If I remove the overcut, the circle's cut path shows up. See screenshot.
I am running Ubuntu 12.04, SheetCam TNG Development 5.1.12 under Wine. Any ideas?