new angle threshold feature not working

TIG · Post by **TIG** » Wed Sep 04, 2013 4:49 am

I'm working with a lot of inside offsets on angles greater than 100 degrees. For outside offsets this is not a problem because the corner loop option is always there. Not the case for inside cuts...nor does the new angle threshold upgrade appear to be doing anything. Am I using it incorrectly? I have tried every combination of settings I can think of. Attached is a pic of some 110 and 120 degree angles that are giving me radius corners where the program calls out for zero radius.

Post by **Les Newell** » Wed Sep 11, 2013 9:28 pm

Sorry it took me a while to reply. What angle threshold are you working with? Can you show me the settings you are using?