Hey all looking for some help with my sheet cam ...I updated to ver3. from 2.11 I think anyway my start point seems to wan't to be the middle of the sheet not down in the corner where I tell it to be .... Anyone know how to fix this ? I am using autocad, mp300.mach 3 on plasma table... I am fairly green on all this ..
Thanks,Plasmabob
Start point ?
Sure hope someone is there to provide some feedback!
learn-language http://http://www.learn-language.me
Testking OG0-093 Testking OG0-093
Testking rhce Testking rhce
Testking vmware certification Testking vmware certification
learn-language http://http://www.learn-language.me
Testking OG0-093 Testking OG0-093
Testking rhce Testking rhce
Testking vmware certification Testking vmware certification